![]() ![]() Wards Riverside mopeds 1965-1967 (Benelli). EPA motorcycle noise standards.Parts Manual 4. This motorcycle is designed for closed course competition use only. (2), (3) and (4) of this section with the statement: Shall be labeled in accordance with the provisions of paragraphs (a)(1), (c) Any competition motorcycle as defined in Sec. Provisions of paragraphs (a)(2), (3), and (4) of this section with the Outside the United States must be clearly labeled in accordance with the (b) Any vehicle manufactured in the United States solely for use Manufacturer abbreviation as soon as reasonably practical after his Subject to this regulation, the Administrator will assign him a 3-letter (9) If a new motorcycle manufacturer begins production of vehicles (8) Moped manufacturers only shall use the following abbreviationsĪMF. (7) All motorcycle manufacturers shall use the followingĪbbreviations in their model specific code.īMW. Spaces for the advertised engine displacement respectively. Of this section), three spaces for the class identification, and four Three spaces for the manufacturer's abbreviation (see paragraph (a)(7) (6) The model specific code is limited to ten spaces which includes Noise standards are prohibited by Federal law. Modifications which cause this motorcycle to exceed Federal (serial number), meets EPA noise emission requirements of - (noiseĮmission standard) dBA at - (closing rpm) rpm by the Federal test This - (model year) - (model specific code) motorcycle,. (i) The label heading: Motorcycle Noise Emission Control (5) The label must contain the following information: (4) The label must be lettered in the English language in legibleīlock letters and numerals, which must be of a color that contrasts with Vehicle in such a manner that the label cannot be removed withoutĭestroying or defacing it, and must not be affixed to any piece ofĮquipment that is easily detached from such vehicle. (3) The label must be affixed by the vehicle manufacturer to the ![]() Otherwise permanently attached in a readily visible position. (2) The label must be plastic or metal and be welded, riveted, or Paragraphs (a)(2), (3), and (4) of this section, to all such vehicles to (a)(1) The manufacturer of any vehicle subject to this subpart must,Īt the time of manufacture, affix a label, of the type specified in 205.158 PROTECTION OF ENVIRONMENT ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) NOISE ABATEMENT PROGRAMS TRANSPORTATION EQUIPMENT NOISE EMISSION CONTROLS Motorcycles 40 PROTECTION OF ENVIRONMENT 12 false Labeling requirements. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |